Integrated AC & DC Design & Analysis
Model-Driven SCADA, EMS, PMS, ADMS & SAS
Leverage Analytics with a Unified Digital Platform
A Unified Digital Twin Platform Design, Operation, and Automation
Quick Links
Part 1 – System Modeling & Studies for Existing Systems
Intergraph® SmartPlant® Electrical working with ETAP® can help to achieve business objectives and offer a unique solution in the market of engineering, design, validation of data, construction support, commission, and operations.
The ETAP Nuclear License is used throughout the world by nuclear generation plants, research laboratories, consulting firms, government agencies, etc.
ETAP Real-Time is an energy management software application that runs as an operator workstation to monitor, control, and optimize the operation of your power system, while simultaneously serving as an engineering workstation capable of utilizing real-time data to perform full spectrum power system analyses.
Optimal Capacitor Placement - Costs Benefits Due to Loss Reductions
This white paper discusses the implementation of a voltage control switch capacitor scheme by means of the user-defined dynamic modeling (UDM) tools in ETAP.
This white paper provides a comprehensive discussion of the modeling of Mersen’s medium voltage controllable fuses (MVCF) in ETAP.
Power engineers are using ETAP to model wind turbine generators, model turbine and controller characteristics for dynamic stability analysis, and calculate megawatts (MW) and reactive power generation based on wind speed and turbine characteristics.
This paper presents a method for the optimal allocation of Distributed generation in distribution systems.
Instructions on how to use OLE and ActiveX objects.
This Paper investigates the impact of power system harmonics on the performance of over-current relays.
This article presents different methods for assessing the hazards of high- and low-voltage 1-phase equipment. One common question being asked is how to determine the hazard level associated with 1-Phase (1-P) Arc Flash (AF) incidents. There is very little information about this type of circuit in the available guidelines such as CSA Z462-08, NFPA 70E 2009 & IEEE 1584 2002. If the right risk level is not properly determined, we run the risk of over-protecting or under-protecting personnel that are working on this type of electrical system. The objective of this article is to present different methods for assessing the hazards of high and low voltage 1-P equipment, and to justify the results taking into consideration the behavior of arc faults at different voltage levels.
Methods available for calculating the incident energy released by an arc fault in low-voltage equipment and considerations to determine the worst-possible hazard associated with energized work at different locations of the equipment.
This article sheds some light onto the assumptions and generalizations utilized by the NFPA 70E Table 130.7(C)(9)(a) and to describe its limitations and shortcomings which may lead to an improper selection of Personal Protective Equipment (PPE).
This article explains how arc flash software is essential to identifying and analyzing high-risk arc flash areas, so you can help keep your electrical staff safer.
It's important to understand the Hazard/Risk Category levels listed in NFPA 70E, but just as important to understand the limitations of these tables.